FlyerTalk Forums - View Single Post - Programming with a projector
Thread: Programming with a projector
View Single Post
Old Mar 17, 2013 | 1:07 pm
  #5  
tkey75
FlyerTalk Evangelist
10 Countries Visited20 Countries Visited30 Countries Visited15 Years on Site
 
Join Date: Oct 2005
Location: Somewhere between here and there...
Programs: WWF, Appalachian Mountain Club
Posts: 11,595
Originally Posted by chx1975
I would love to pick a 16:9 screen but there are no tabletops with that ratio I can find quite probably because most portable projectors are XGA (4:3) or SXGA (5:4, close enough to 4:3).

Thanks for the heat warning I was actually thinking on doing just that :/ I might need to find a good rear projection screen perhaps.
RP is a bad choice for portable projectors. First off is all the space they waste. You'll throw away 8-10' of the room your in. Next is with the lower lumens, you lose even more with RP.

If you do go that route, make sure the pj has the display option to do floor/rear. A lot of portable pj's don't.
tkey75 is offline  
Reply