Airport Code Look-Up is messed up
 

Today I tried to use the Airport Code Look-Up from the link at the bottom of a page in the DL forum (and also again from a couple different pages). The Airport Code Look-Up page looked exactly as I expected, as it usually does. The code I entered was PLS and then I clicked on submit as usual.

The result I get looks like a FT page in that it has the normal FT stuff at the top. However, most of it is a white area with to paragraphs of text separated by a lot of white space with the word "to" in the middle and a couple boxes in the text. Inside the boxes is the following: "$cities($X)". The text looks to me like it's coding.

Added: I just tried it again using the link on the bottom of this page and the airport code MSP. The result was the same.

It is truly buggered up.

The result for SFO was two boxes, duplicates:

["$cities[$x]"]

(bold for emphasis only)

Reported. Tech is working on a solution but it will involve rebuilding the tool. No time frame as yet.